1. MOUNT ARAID
  a. Turn the computer off.
  b. Remove the primary drive from computer
  c. Mount the ARAID unit into an open 5-1/4" drive bay.

2. Connect Cables
  a. Connect an EIDE or SATA cable from the PC drive port to the ARAID.
  b. Attach the power cable

3. Attach Drives
  a. Insert your pre-existing hard disk or a blank disk (for new systems) into a tray and slide it into the ARAID's top bay.
  b. Insert a hard drive into a tray and slide it into the ARAID's bottom bay. ALL PRE-EXISTING data on this disk will be overwritten.

4. Boot
  a. Power on the computer. The computer will boot off the pre-existing, drive in the upper bay.
  b. ARAID will automatically begin copying the primary drive to the secondary drive in the lower bay when the mode switch is changed from “Single” to “Default”.

5. Protect Your Data!
  a. ARAID automatically writes to both drives so you always have a 100% backup in the event of a disk failure.
  b. Using a third drive and tray with ARAID allows you to keep archive copies off-site similar to magnetic tape, but faster, easier and more economical.

6. Register Your ARAID
  a. Register your ARAID product at www.accordancesystems.com/support for warranty protection, email support and special offers.